Here’s a no-PCB Arduino that doesn’t obscure the DIP footprint of the AVR chip. It’s built on an ATmega88 chip, and includes a programming header, reset button, a couple of filter… ...

This tutorial will guide you through the process of building a tachometer around an Arduino. Tachometers are used to measure rotation rate in Revolutions Per Minute (RPM). You don’t need much… ...

4. Connect the breadboard rails to Arduino GND and +5V, and then check that your setup matches that of Figure 10-3. Mounting the Laser For this project, I’ve attached the servos to a pan-and ...

Before opening the Arduino software, wire up the Arduino according to the circuits page using the 8MHz minimalist breadboard circuit but with a 10k pull-up resistor on the reset pin (physical pin 1).

This is a simple 0 to 9 counter circuit constructed using Arduino! Here, a common cathode 7-segment LED display is connected to Arduino for displaying the digits. The code (Arduino sketch) allows push ...

Follow this DIY table tutorial with breadboard ends for a classic touch to your dining area.

Digi-Key Electronics has signed a worldwide distribution agreement with LogiSwitch, makers of the Arduino-friendly NoBounce line of ICs and switches. The company writes: LogiSwitch’s adaptive NoBounce ...